I showed it before, and it works really well, cutting a rabbat using a table router.
Here I glued two strips together.
Subscribe to:
Post Comments (Atom)
What is a F82?
A fast cruising/racer trimaran 8.2 m long. The boat can fold to go on a trailer.
ON THE SLIP
As seen here you can go anywhere with this boat.
The former model F25C
About Me
- MartinF
- Hobro, Denmark
- Boatbuilder of the old school, but building this very modern boat for myself.
Popular Posts
-
I use the Australian word, bog for this. The American/English word putty sounds like something you might eat..... Bog is a mix of epoxy and ... -
I forgot to post this picture but it shows hull after vacuum bagging inside laminate, including uni carbon strip along keel. Also I cut down... -
Hi all It's been a long time but this project is not over yet allthough some might have that thought..... I tried to infuse the outer ha...
-
For my fellow trimaran owner/builder Per Folm Hansen I made an attempt to rebuild an older daggerboard to a High aspect shape that is Larry ... -
Daggerboard case is normally done in plywood and wooden battens, but i saw that the F22 is done over a mold with glass tapes as joints. So ... -
Hi there a note from the no-workspace-at-all department. I fitted the ancherwell floor in place before fitting the starboard side of the f... -
Planking in progress, note extra 5cm stringer at top for vacuumtape, also extra stringer where high density insert along keel. I start at in... -
I just got hold of a Marstrom carbon mast, only problem is that it is in two parts. I should be able to join the pieces where th... -
Bow with HD for winch u-bolt. Carbon tube for bowpole stay(?) Daggerboard case with carbon stringers. The red color comes from the spray a... -
Crawling along inside adding peelply , I kneel on some layer of soft foam. Did all by myself and it went allright with slow ...
No comments:
Post a Comment