I use a circular saw to cut strait lines using a guide that will cut right at the edge.
A jigsaw metal blade used for curved cuts.
Using an old template from the floats to support bulkhead while cutting.
Introducing RulleMarie (Rolling Marie) an old kitchen with wheels fitted. Here I use it for supporting mainbulkhead before glassing it.
2 comments:
I found my self drooling in front of one of those circular saws a while back. I was able to withstand the urge to buy one at the time.
Yes it is really good, this is my second and I upgraded the size this one cuts 75 mm deep. But the smaller one is proberly fine for most builders, it cuts 55 mm and is lighter. I use a lot for cutting strait cuts in plywood etc. It is much easier than balancing a full sheet on the stationary mashine.
Post a Comment